BONDING DESIGN GUIDETwo of the major factors influencing the design of lap joints is the magnitude and direction of the load that the joint must bear. Most adhesives used for bonding flat surfaces are relatively rigid, strong in shear, and not so strong in peel...
MAX CLR-TC A/BCLEAR LIQUID RESIN -TOP COAT3/4 Gallon Combined Volume½-Gallon of MAX CLR-TC PART A RESINAND1-Quart MAX CLR-TC PART B CURING AGENTFormulated With Surfactants That Improve Substrate Wetting, Reduce Air Bubble EntrapmentEliminate Surface Blemishes Such As Bénard Cells, Orange Peeling, Fish Eyes, Pin Holes, And...
PROPER EPOXY MIXING TECHNIQUE - Avoid tacky or uncured spots and low air bubble mixing - YouTubeVideo will open in a new window · Allow the applied resin to fully cure for a minimum of 48 hours at 75°F before exposing the coating to any...